Looking for feedback on RERF for Photon Mono X
Got my Photon Mono X a few days ago but didn't have time to set it up and get to testing until yesterday. My first print of the test cube was an absolute fail so I re-levelled the build plate and decided to print a resin test (using AnyCubic Eco Grey).
The result is below. Top row is 0-4, bottom row is 5-8 (from left to right) with timings starting a 0.8 and going up by 0.4 with each. Recommended is 1.8 to 2.0 from the manual.
Personally, I think quality is "good" starting around 4 (2.0s) and may peak around 7 (3.2s). I think some of the disfigurations were caused by me dropping the prints into my Wash & Cure -- I think the agitation did more harm than good and if I were to print one again, I'd more gently dip to rinse.
I'm actually surprised that 2 (1.2s) turned out as good as it did.
Anyway, I'm looking for more feedback on how to interpret this -- I can print another (it takes about an hour) or provide pictures of this from other angles if it would help.
Never had to do one of these with my original Photon so I'm not entirely sure what I'm looking for beyond the super obvious.
