New light installed and won’t turn off.
Hi—I replaced my ceiling fan/light for a regular light fixture.
The fan’s box had three wires: black, white and red. Ground wire was also there.
The light fixture has black, white and ground.
The fan’s box was controlled by a dual switch. One side turned on the fan and one side turned on the light.
I have installed several new lights in our home over the last few months. I’ve pretty much replaced all of them save for one or two. The others are working fine.
So…, hubs is out of town. He discouraged me from tackling this new install solo because it’s on a sloped ceiling that is pretty high up. New fixture is a bar fixture with six globes.
Of course a soon as his car left the driveway I was hauling in the ladder and getting busy on the light install.
I connected black to black, white to white and capped of red. Ground wires connected and capped.
The light comes on with the switch. It is a dimmer, so the first click the light is very low. Click again and it goes full brightness. Both switches will turn light on to full bright. Only one dims.
The light will not go completely off. It I’ll only go to dimmest setting but not off. It also stays at dim unless I click the switch again. Then it goes full brightness.
Le sigh…, it was difficult to do by myself. Only one side is hardwired. The other mount is to hold the weight of the fixture (no wiring, just a canopy and screws).
While I hope I do not burn up in my sleep, I will tackle the wiring again in the morning. My arms are spaghetti and my back isn’t super happy from pressing into the tall ladder to keep from falling.
Should I connect my live black wire from fixture to the red wire? Cap off black wire?
I don’t need both switches anymore, but I’m not sure how to do switches.
(My dad was a master electrician. He died a few years ago and I really, really miss him. He was the best. I’m doing my wiring myself to try to learn so I am not reliant on electricians for basic things.)
TIA for any advice.