Allow disabling gap fill in Bambu Studio

Unless I'm completely blind, I didn't find an option to disable gap fill in Bamb Studio.

In case you don't know what I'm talking about: When finishing a top shell layer, you'll notice that the printer will often travel quickly between a few spots, trying to fill up gaps caused by the infill pattern by extruding a small bit of plastic.

On some plastics and models, that can improve quality, but recently, I had a few prints where the top layer looked fine as it was, and the printer just added unneccessary zits to the print when trying to fill the gaps.

Did you ever notice that problem? I'd love to hear your experiences.

I hope Bambu will add a checkbox in order to disable this function.