Bad Overhangs

Hello guys,

I seem to be running into an issue with overhangs while printing. Every time I print, the overhangs come out looking pretty rough, even when they are not that steep.

In the first photo, you can see that the speed stays at a consistent 199 mm/s, even though I have “slow down for overhangs” enabled along with my custom speed settings. In the second photo, you can see what I mean when it comes to the overhang issue Im running into. I can’t seem to figure out what I’m doing wrong.

The only way I’ve been able to get it to behave closer to what I want is by adjusting the max/minimum layer time/cooling settings under the filament profile. However, that slows down the entire print, not just the overhangs.

Has anyone else run into this issue or know what setting I might be missing? Any help would be appreciated.