Varying flash combination capabilities on Lumix G9, specifically focus bracketing
I have two different brands of flashes and triggers (Yongnuo and Godox). The Yongnuo flashes (YN660) and wireless trigger (YN560-TX) are manual only with no camera communication, yet the camera can sense when they are switched on, I assume from trigger voltage.
When it senses a dumb flash attached, the camera will slow down the drive mode, and disable things like focus bracketing. The G9 manual does *not* list focus bracketing as one of the unusable modes with flash (obvious ones like silent mode and any SH drive mode are listed as unusable). The behavior is the same whether the flash or the wireless trigger is attached.
With the Godox flash, a small TT350o, the camera has TTL capable communication (not specifically important to me, I use manual flash). The drive mode in H is now *disabled*, as is focus bracketing. Focus bracketing wasn't a surprise considering the experience with the other flashes.
Using the same flash with a Godox X2 trigger, the behavior unexpectedly changed again. Drive mode H is now available again, but even slower. And by total accident, I found out focus bracketing works. And, just to frustrate me, appears to work at a higher rate than drive mode H. Also with the trigger, there is a barely noticeable delay in taking single frames in manual flash, where there was no delay with just the flash, or with Yongnuo either with just flash or with the wireless trigger.
Reading manuals so far has not turned up anything. All I want is to be able to predict the capabilities of different equipment combinations before I buy them. Will larger Godox flashes support higher burst mode speeds? Will any flash support focus bracketing if mounted directly to the camera? Does the newer G9 ii behave differently here? I have an S5 ii that I haven't tested yet, but I don't do macro with that one so the results would be just a curiosity.