Help improving my foundry
Hey team. I’ve had a small oil-fired foundry for a while, and it works well enough to melt a couple kilograms of aluminium. My issue is how hard it is to light and keep burning nicely - I have to start on wood and very very carefully transition to oil. Otherwise it either smokes like crazy or the wood runs out and the foundry cools.
My fuel injector is very hacked together from 25mm galv fittings and a reduction right by the entry to the foundry. In principal, this is the backyard metal casting’s hot shot. I fuel this with waste oil dripped near the reduction (mediocre Venturi, but just enough to keep the oil drawing down my hose. I provide air with a modest shopvac, and I have a diy butterfly valve before the air goes into the furnace (not on the vacuum intake).
I’ve thought about a few areas I might improve things - but I’m not sure what’s the best bang for buck. Firstly, perhaps I need more air to help burn all the oil before the smoke leaves. That would require me to buy a big blower. Second, maybe my 1/4 turn ball valve (1/4”) isn’t adjustable enough for the oil - so upgrading to a needle valve. Finally, maybe I should use an air compressor (that I don’t own) to atomise the fuel and make it easier to burn.
Thoughts? What I have works, not it’s a real hassle to start and I end up not bothering.
Here’s an album of a couple progress pics. Main change was swapping the fan for the shop vac. That cart is great and immediately made it more pleasant to take out of the garage! https://imgur.com/a/hBM8opi