RedditPP Mascot

RedditPP

r/Ubiquiti • … • u/NinjaCoder

Poor mesh performance U6LR's after firmware/controller upgrade

Just wanted to ask here in case someone has some suggestions, or has also had this happen.

I have a pair of U6 LR's placed 76 feet apart (see image [here](https://imgur.com/a/uPs9YZc)).

The one on the garage (A) is under the overhang, the one in the main cabin (B) is on a ceiling, one wall (exterior) in the way. The garage unit is meshing to main cabin unit.

I was running an Edge Router X and the old Java controller software to manage the APs. Nothing has changed with the mounting of the APs.

Standing near the garage (point A), I could get around 200Mbps+, and I could get a reliable 2.4G signal all the way to point C or farther.

After I set this up, I didn't mess with it at all. It worked flawlessly for 3 years.

Recently, I upgrade the Edge Router X to a Cloud Gateway Ultra and moved the APs to the built in controller. As part of that effort, the units upgraded their firmware.

Since that move, I am lucky to get 75Mbps at the garage location, and the distance to point C is about half of what it was. The meshed node reports "poor" signal to the base unit. Inside the main cabin, I get blistering speed from the 5GHz (600MBps+).

Unfortunately I did not record what the APs were set to, or what firmware they had running.

To improve this I have tried:

(1) putting everything in auto

(2) changing 5GHz channels manually

(3) changing transmit power to "high"

(4) changing 5G channel width to 40/80/160

(5) some combinations of 2 and 3 (including setting power to l/m/h/auto) and 4.

Nothing really makes much difference.

This spot has very little WiFi interference, and on the 5G spectrum I am completely alone. In the 2.4G, there are completely clear channels at 1 and 11, which the "auto" selects.

Ordinarily I would just say "I guess it is just too far for this mesh"- but it used to work SO MUCH BETTER.

Anyone have any ideas about why this happened or what I can change to improve it?

As for adding new hardware to fix it, I was thinking about trying a UDB-Pro at the garage location to backhaul for the U6 LR there. I have also considered replacing the U6 LR with a U7 Outdoor, thinking the directional antenna will improve the mesh reliability. Am I on the right track here?

If I can't find a reasonable way to improve this, I will likely run cat6 to the copper roofed building to left of the garage (the garage had a concrete apron installed after this image was taken, so I can't run it to the garage).

Thank you in advance for your help/ideas/sympathy....

— 0