RedditPP Mascot

RedditPP

r/arduino • … • u/WithGreatRespect

Can WS2812B (neopixel) addressable led strips be run in series to raise the voltage?

I have, in the past, ran long runs of single color led strips in parallel wiring configuration (physically still in a single long line) in order to:

* double the voltage of the power supply and related wiring * due to higher voltage * have longer distance between the supply and the leds without voltage drop * avoid needing a buck converter near the strip to drop from supply voltage to strip voltage * avoid needing thicker gauge wires and/or power injection for long runs.

I am curious if this same strategy can be used for addressable WS2812B strips that are controlled by an Arduino and wired with external power supplies.

I simulated in Tinkercad and the normal parallel wiring setup works as expected, and switching to series configuration shows the strips are getting the correct voltages, but the simulator doesn't seem to show them lighting up. This could just be a limitation with the Tinkercad simulator, but before I blow up an Arduino or some strips, I figure I would pose the question here.

Would the ground from the 10V circuit coming back to the Arduino be a problem? I don't think the data line is at issue since there is no connection to the 5V/10V lines in either circuit configuration.

Please see these diagrams showing a normal parallel circuit and then the proposed series circuit:

***PARALLEL - KNOWN RECOMMENDED CONFIGURATION***

![img](oeg1rb4swc3a1 "WS2812B 5V Strips wired in Parallel with external power source.")

***SERIES - PROPOSED CONFIGURATION***

​

![img](24qa86zcyc3a1 "Proposed: WS2812 5V strips wired in Series with external power source")

— 0