Looking for feedback on my "palm down" controller offsets (Quest 3, default grip)
Hello everyone,
I'd like to try the "palm down" grip variant—essentially slapping the cubes instead of chopping them. I'm not a fan of the chopping motion because it causes wrist pain, and the limited range of motion makes it difficult to perform a full swing.
Is there a guide available on how to set this up correctly?
Here are the steps I've taken so far:
1. Adjust the wrist pivot point (position offset) using EasyOffset, and then transfer the settings to my standalone headset. 2. Manually tweak the Rotation X so that the saber aligns with my index finger. My hand position is relaxed and neutral, positioned slightly in front of my body.
My current offsets are:
* **Position:** X +2 cm, Y -4 cm, Z +2.4 cm * **Rotation:** X +44°, Y +5°, Z 0°
Does this look like a good starting point? Are there any glaring mistakes here?
After several test runs, I've noticed that it's easier to get good accuracy on simple line patterns, but overall gameplay feels much harder.
Any advice would be greatly appreciated!