RedditPP Mascot

RedditPP

r/chevycolorado • … • u/Secret-Ad-7909

First Gen Brake Upgrade

Spent the weekend working on my 07 z71 4x4. At 290k miles the original (or maybe salvage yard?) rotors were getting grooved and too thin to resurface.

The first generation had some big updates later in its life cycle. Bigger brakes was one of them. But when they did this the spindles stayed the same so this is a *relatively* easy upgrade. Just buy the rotors, pads, and calipers with brackets for an 09+ truck. I went with a Powerstop kit from RockAuto.

I say relatively easy because the rotor design for this generation is kind of a pain. They’re bolted to the hub assembly between the lugs/wms and the spindle. So the hub assembly must be separated from the spindle.

As you can see from the pictures I elected to do this by pulling the whole spindle off the truck. The bolts that hold the hub assembly to the spindle are very difficult to access due to the CV axle, I assume this is easier on 2wd trucks. I’ve had the hubs off several times so I’ve kinda got a system down.

Includes comparison pics of some of the components and test fitting inside the wheel. I’m running 20s. At least 18s are required to clear this setup.

So far I like it, feels like a moderate upgrade. Hopefully it comes in handy when I start pulling a boat.

I’ll probably do new lines and paint the calipers soon. I have a plan to swap to disc brakes in the rear but that will involve swapping the whole axle and there’s a couple other things I’ll do at the same time.

— 0