RedditPP Mascot

RedditPP

r/consolerepair • … • u/DangerousCousin

[Wii] Accidentally killed the component/s-video luma output. How difficult is it to replace the encoder chip?

So I was attempting an s-video mod on a CRT TV, using my Wii as a test device. The Luma (Y) wire apparent wasn't soldered well and broke off and dragged across some the board near the RF input.

I imagine there were some higher voltages in that area. My Wii went into standby mode. I panicked and went to pull the wire out of the way, dragging it across more solder points. Then the Wii goes black 🤦

So big mistake. Afterwards, component and s-video don't work because the Luma output is dead.

I'm hoping perhaps just a series resistor/capacitor before the encoder chip was burned open, which I will test for later, but I fear the encoder itself now has a short to ground on Luma.

Has anybody attempted to replace the Wii's video encoder before? Is a basic hot air gun enough?

— 0