RedditPP Mascot

RedditPP

r/espresso • … • u/Macusercom

Sage/Breville Bambino Plus: The Complete Cleaning, Maintenance & Button Shortcut Guide

Depending on the market, this machine is sold as either the Sage Bambino Plus or the Breville Bambino Plus. It is essentially the same machine, so this guide applies to both.

I recently bought a Sage Bambino Plus and was surprised by how much conflicting information I found online, sometimes even compared with the manual.

So I decided to put together everything I've learned about cleaning, maintenance, descaling, common issues and useful button combinations, along with a few things I've noticed myself.

This isn't meant to replace the official manual. Think of it more as a practical owner's guide.

# TL;DR: My Maintenance Routine

|Interval|What I do| |:-|:-| |Before every coffee|Run one blank shot| |After every coffee|Run one blank shot| |End of the day|Manual water backflush 2-5x| |About once a week|Backflush with cleaning detergent| |About once a month|Remove and clean the shower screen| |Regularly|Run the automatic cleaning cycle| |Depending on water hardness|Descale| |As needed|Thoroughly clean the steam wand|

# 1. Before and After Every Coffee

Before making coffee, I run a blank shot with the portafilter inserted.

In my experience, this helps bring the group and portafilter up to temperature.

After pulling the shot, I run another blank shot. This helps rinse away coffee residue, especially around the shower screen and the center screw.

# 2. Manual Backflush at the End of the Day

At the end of the day, I do a few short water-only backflushes depending on how much coffee residue still is inside.

**Here's my process:**

1. Insert the cleaning disc / blind basket into the portafilter. 2. Lock the portafilter into the machine. 3. Briefly hold `1 CUP` or `2 CUP`. 4. Release the button. 5. Let it run for about 10 seconds. 6. Press the same button again to stop.

**Why briefly hold the button?**

Holding `1 CUP` or `2 CUP` gives you manual control over pre-infusion. Once you release the button, full-pressure extraction begins.

For a backflush, I don't see any reason to use an unnecessarily long pre-infusion.

When you stop the shot, pressure is released through the 3-way solenoid valve and the water is discharged into the drip tray.

For every shot I would empty out the portafilter as coffee residue inside the portafilter might get blackflushed if you do not empty it out between backflush cycles.

More on the resulting splash problem of the drip tray further down.

**Mapping The Buttons**

I have use the `1 CUP` button for blank shots and backflushes and the `2 CUP` button for my actual shot. In my case I use a double shot basket anyway so it makes the most sense. You can do the opposite or just use the same shot volume for your espresso. The amount of water should not matter for cleaning "shots".

# 3. Weekly Backflush With Detergent

About once a week, I repeat the same procedure using espresso machine cleaning detergent. Water will be backflushed into the drip tray.

I use roughly 3g of cleaning powder in the blind basket (e. g. pulyCAFF).

The process is essentially the same as the manual water backflush.

The detergent helps remove coffee oils that plain water won't completely get rid of.

# 4. Cleaning the Shower Screen

About once a month, I remove the shower screen and clean the inside.

You'll need a: Phillips PH2 screwdriver (PH3 could fit as well I think, PH1 or Pozidriv do not)

[https://imgur.com/rfqGffh](https://imgur.com/rfqGffh)

*Important: use a relatively short screwdriver, otherwise there isn't much room to work underneath the group head.*

Coffee residue and oils tend to build up behind the shower screen over time. If it does want to come out, gently use the screwdriver with the PH2 bit or a smaller bit to lever the shower screen from multiple directions until it comes off.

After cleaning it, simply reinstall it but do not overtighten the screw or it could bend the shower screen. It should simply be flush and not stick out.

You can also inspect and occasionally clean the gasket while you're there. It doesn't need to be cleaned every single time, since most residue accumulates directly on the shower screen.

# 5. Automatic Cleaning Cycle

The Bambino Plus will eventually request that you run its cleaning cycle after a 200 number of cycles.

For me, this happens relatively quickly because blank shots and cleaning operations also contribute to the machine's internal counter. The automatic cleaning cycle is essentially an automated backflush.

I use it regularly in addition to my manual backflushes, e. g. instead of doing it manually with pulyCAFF I use the automated one every 1-3 weeks depending on the usage, so the Bambino Plus never complains mid-week about needing a cleaning cycle despite having it manually backflushed with cleaning powder).

# Manually enter cleaning mode

* Insert the cleaning disc into the filter basket and place a cleaning tablet/poweder on top * Lock the portafilter into the group head * Empty the drip tray and put it back * Place a 2 L container under the portafilter and steam wand (just in case it drips a bit and the steam wand will be flushed at the end once) * Fill the water tank to MAX

With the machine off (all lights off), hold:

`2 CUP` \+ `STEAM`

for **5 seconds**. `1 CUP` and `2 CUP` will light up.

Then press:

`1 CUP` or `2 CUP`

to start. The lights flash alternately during the cycle. It does about 10 backflushes with different timings, then flushes the steam wand and after that returns into ready mode. It takes about 5 minutes. Rinse portafilter, disc, drip tray and container afterwards.

*(Note: If the cleaning alert is already showing, 1 CUP / 2 CUP flashing — hold* `1 CUP` *+* `2 CUP` *for 5 seconds instead. Holding them for 2 seconds or longer without alert enters shot-volume programming)*

# 6. Descaling

Descaling works differently from the regular cleaning program. It takes approx. 10-15 minutes.

— 0