RedditPP Mascot

RedditPP

r/homelab • … • u/Emergency_Ad7839

r740xd hanging on initializing firmware interfaces

Hi all,

Somewhat of a novice here.

I am having an issue with the r740xd hanging on initializing firmware interfaces before POST. This is a a new setup. TrueNAS install bare metal on a dell BOSS card. I havent started created pools yet given these boot issues.

It boots fine without the SAS drives in. But when I put the SAS drives in and cold boots- it hangs here. Notably it's fine when I remove the SAS drives and then insert them later as a hot swap. But whenever cold booting, the SAS drives prevent it from going more.

The firmware appears to be mostly up to date. I have the Dell HBA330 mini as the controller. Using Exos18 SAS drives.

Ive tried NVRAM pin restart and disabling the CSIOR.

UPDATE:

Thanks for all the help, especially u/HanSolo71 for all the troubleshooting back and forth.

After many hours over the weekend trying lots of things, it ended up being a quick fix (as I suspected). The root cause was that there were some retained metadata on the drives (a whole 2 bytes!). The hard drive supplier figured this out- running wipefs in trueNAS worked like a charm. Still odd that I couldn't see boot configuration for this controller in BIOS, but whatever I guess. Below are the steps I did in case someone in the future runs into the same problem:

1. Remove all non-bootable hard drives from the panel. 2. Cold start and boot into trueNAS on the BOSS card 3. Once past POST, hot-insert all the hard drives. Wait until they spin up. 4. In shell, run: sudo wipefs /dev/sdX for each drive (where X=drive number) \[can use sudo lsblk -d -o NAME,SIZE,MODEL to determine drive letter). 5. cold restart, should POST now

— 0