Wrote about how an HVAC system works for my students
I wrote this for my first month students so they can understand how a refrigeration/HVAC system works. But it's written and explained in terms anyone can understand. If you want to learn, read below. Please leave feedback and let me know if you understand it or where you start getting confused.
Let's learn what hot and cold is . Technically, there is no such thing as cold. Cold is actually the absence of heat in the air around you, so when you think it's cold, it's just less heat. As long as molecules are in motion, there is heat. Heat is gone when molecular motion stops which is what is called absolute zero. The temperature of absolute zero is negative 459 degrees F or negative 273 degrees C. So even at zero degrees in the middle of a blizzard, there is still heat in the air, this is why a heat pump can work at low temperatures.
First, let's talk about how your system is able to blow cold air out of your vents. When the system is running, you have 100% liquid flowing towards your coil. Right before your coil you have a metering device. It could be a piston or a TXV. What happens is the high pressure high temperature liquid coming from your outdoor unit hits the metering device which creates a pressure drop across it. When this happens, the refrigerant flashes which means its temperature and pressure drops becoming a low temperature low pressure vapor/liquid.
After flashing the, liquid/vapor travels through the evaporator coil and it absorbs heat which causes the vapor/liquid to boil off as it's absorbing heat. As it boils off, the gas boils off is expanding. This is why you have a little pipe going in and a big pipe coming out. There is 2 types of heat the evaporator coil absorbs as it boils off. Sensible heat, which is heat you can feel a temperature change with. Then you have latent heat which is heat you can't feel because this heat causes a change of state which is why your coil drips water. Latent heat is absorbed and water in the air changes state from vapor to liquid.
At one point in the evaporator coil, all the liquid is boiled off and only gas remains which is good. In the last 10% to 20% of the coil, the gas that was boiled off continues to absorb heat which is called superheat. Superheat is the temperature added to gas after it's bubble point. This happens because liquid going to a compressor is very bad. So to make sure the compressor only gets gas, we superheat it. 10° of superheat is how much heat has been absorbed after it's bubble point and guarantees us no liquid is going in the compressor.
Now, the compressor does exactly what is says it does. It takes a low temperature low pressure gas and turns it into a high pressure high temperature gas. Why? The laws of Thermodynamics tells us that we can release heat better in refrigerant if we compress it. Think of the compressor as a pump too because of it, refrigerant is able to move through your system
As the refrigerant enters the outside coil, the fan blowing moves air across the coil and releases the heat absorbed inside the house. The heat absorbed inside gets compressed by the compressor and that compressed refrigerant gas is much hotter and at a much higher pressure than it was before the compressor. While the air outside feels much hotter than the air that was absorbed inside, laws of thermodynamics is just moving heat from where you don't want it to where it doesn't matter. The aluminum fins help dissipate the heat in the coil. As the refrigerant moves through the coil, it starts dropping in temperature until it reaches its saturation point. At this point, the refrigerant condenses from a gas to a liquid. If you put your hand over the fan, you can feel the heat that the refrigerant is releasing.
Towards the end of the coil, all the gas has turned to liquid and now this liquid starts to get sub cooled. That's the heat removed after the saturation point. Now this 100% liquid travels down to your coil and starts the process all over again.