RedditPP Mascot

RedditPP

r/klippers • … • u/EnvironmentalName748

My corexy printer hits a speed wall at ~20 minutes

Im trying to get a (good looking) sub 10 minute benchy, but whatever slicer tweaks I do I could not get it under 19:19. When I look at a a1 mini it can print one in under 15 minutes but has slower accel and the rest stays pretty much the same.

My printers capabilities should be enough (at least I think so based on some research):

14 accel on x and y (according to input shaper)

500mm/s max speed

32 mm\^3/s flowrate

2 high rpm 4010 blowers for part cooling (just for the good looking part)

I have tried everything in the slicer, but I just cant get it faster. Ive looked through the standard settings that may slow me down (e.g. minimum layer time, square corner velocity, flow limit)

anything that may slow me down? or is this just my printers limit?

fyi this is the DuEnder by sergei irbis, great first self-built printer!

Edit: I found what was slowing me down. It was the "maximum acceleration for extruding" that was set on 5k. I thought that was the accel for the extruder motor but it capped the accel on all axis to 5k for the entire print

Edit 2: Just got my first sub 10 speedboat benchy, 8:52!!! And its not even looking bad

— 0