RedditPP Mascot

RedditPP

r/supermoto • … • u/CarlsbadCO

F brake pad REPLACEMENT q

so I'm replacing the F brake pads on my KX450f as the old ones do not have much bite.

New pads are maybe 1mm thicker [with no wear].

Problem - The 330 SM rotor spins ok when I put the Nissan caliper back on w/ the new pads (spread to get over the disk). I pump the brakes a few times - then I have huge disk drag - like the wheel will not rotate one revolution with a "hard spin." I took a cc or two of brake fluid out of the reservoir as I read that too much may be an issue with the pistons releasing enough - no change. I need to clean the caliper out as much as possible to insure that the pads are not getting hung-up in their slide-tracks but i don't think that is an issue. I am not looking forward to rebuilding the caliper or master cylinder and would like to avoid that.

(I put the old pads back in so I can ride it - stoppies are near impossible w/ the worn pads)

Does anyone have any experience here? Any tips would be appreciated. Thanks in advance

— 0