RedditPP Mascot

RedditPP

r/superslicer • … • u/TyMotor

Can't get Z axis to print dimensionally correct. Help!

This is driving me nuts, and I'm sure the solution is something ridiculously simple... 🤦‍♂️ For the life of me I can't get parts to print out dimensionally accurate along the vertical, Z axis. Parts consistently come out .3mm to tall/thick. I've been through all sorts of calibration steps. The latest was going through SuperSlicer's own calibration steps.

The last one is the calibration cube. From the explanation:

>You have to print two cubes, with different sizes. If the dimensional inaccuracy scale with the size of the cubes, then it's the steps/mm of your steppers that needs some adjustments... If it doesn't scale, you can correct it by adjusting your xy compensation.

When I print a 20 and 30mm cube, my X and Y dimensions are quite accurate. However the Z measurements both read 0.3 over (20.3 & 30.3mm respectively). This tells me my error doesn't scale. The problem is the suggested fix described only addresses X and Y compensation. There doesn't seem to be one for Z.

The xy compensation is on the Slicing tab and within the 'Modifying Slices' section/box. All other settings in that box are set to the defaults.

Is it called something else? Is it achieved via a different setting all together?

In case it helps: Material: PLA+ Nozzle: 0.6mm Base Layer height: 0.2mm

— 0