Wiring help - wall thermostat to wireless
I’ve a very old (original?) tado setup that has been moved from house A to house B.
House A had a controller for hot water and heating, replaced with the extension kit. The thermostat was wireless and tended to live in the living room.
House B has a slightly different setup with a wall mounted Drayton thermostat along with a standard hot water / heating Drayton controller. The extension kit has been swapped over - no wiring alteration needed.
\[Swapping things over didn’t go smoothly: the bridge got stuck in pairing mode, the set up help instructions on a new iPhone gets you stuck in a loop that you can’t get out of as the close button is obscured, so you can’t get back to the screen you need to be at, and force quitting spits you out of the set-up… So frustrating. That along with a very unfortunate failure of a valve actuator at the exact time I was doing all this.\]
So my question is how do I wire up the tado thermostat base plate to keep things operating as they should? The 3 wires (excluding earth) to the 3 unmarked terminals?
For reference, 2 images attached - one showing the original baseplate wiring, and the other showing the tado baseplate with the wiring the result of following the instructions in the app.
My feeling is the wires should just be isolated.
Thanks for any pointers.