RedditPP Mascot

RedditPP

r/telescopes • … • u/Naneyota

Issues with Celestron 8SE and GoTo Mount (Alt-Azm)

I'm having a problem with my Celestron 8SE telescope, which has a Nexstar GoTo mount and a Nexstar Model 4 hand controller.

The hand controller is an older model, so I decided to update its firmware (from NXS 4.14 to NXS 4.22) while keeping the mount's firmware as is, since it appears to be the most up-to-date version (5.14).

Before the update, the mount was able to locate various celestial objects with varying degrees of accuracy. After the update, it started behaving strangely. After aligning with three stars, it locates the first object (Saturn), but when moving to the second (M11), the OTA first moved to the zenith and then began rotating the AZM much farther than where the object was located.

I turned off the mount before the diagonal mirror hit the base and realigned it. The error recurred with the same sequence: the first object was fine, but for the second, it moved to the zenith.

I checked the power supply, and it’s providing 12 V DC. I checked the time, date, and location, and everything was correct. I aligned the telescope using other methods, but it still gives the error.

When using Skyportal, it changes a bit: it locates objects in Alt, but the Azm freezes and doesn’t move.

I rolled back the firmware to earlier versions (first to 21, then 18 and 13, since version 14 isn’t available), but the problem has gotten worse—now it can’t even locate the first object.

I ran one more test: I aligned the telescope, located Saturn (it was off by just a little), moved the Alt using the Hand control, and when I asked it to locate Saturn again (It only had to change the Alt), the Azm reset to 0°. In other words, if it was at 210° 23' 00“ during the search, when I asked it to return to Saturn, it would reset the Azm to 0° 0' 0”.

Of course, with these values reset, the mount moved the OTA to where it now “thought” Saturn was. Naturally, every time I told it to go to Saturn again, it would reset itself to the new physical position at 0° and move accordingly. It kept turning in on itself over and over again...

I've performed a factory reset, reinstalled version 4.22, and nothing has changed.

Please, I desperately need help.

— 0