How smooth should the bead be for the tire to seal properly?
So I’m trying to restore some old steel one-piece wheels I bought for an old truck. I ground off all the old paint and rust, and applied a new coat of primer and top coat (Rust-Oleum Automotive Filler/Primer, and Rust-Oleum’s camo green outdoor matte paint)
However, I wasn’t able to remove these large gouges in the beads, and the paintjob isn’t smooth at all either. So two questions:
1) Are the gouges going to cause slow leakage if I try to mount the tire?
2) Should I sand the beads down and use a glossy paint (like actual wheel paint) for it instead to get a super smooth finish? Or is a rough bead not a a problem/advantageous?