RedditPP Mascot

RedditPP

r/turntables • … • u/TheWaywardOak

TD 160 blasting Art DJ Pre II with noise.

Got my Dad's TD 160 that I posted about recently running, leveled, and aligned. Unfortunately I've run into a snag while setting up the rest of the system. If I connect the RCA cables to the DJ Pre II the peak light goes red and the output is overpowering loud noise. This isn't just some inconvenient hum/buzz; it's an order of magnitude or more louder than the signal from the turntable. If I touch the tonearm the noise changes in character a bit, so maybe it's something to do with grounding? The TD 160 doesn't have a dedicated ground, so I'm not sure what can be done if that's the issue. Putting my little Samson EQ between the turntable and the preamp makes the noise go away, but I don't know if that's an appropriate solution. I've found reports of this preamp coming defective with similar issues, but not this exact one. Not sure how to rule out the preamp being defective because I only have the one preamp and the one turntable.

Secondary issue, when I run through the Samson EQ (with the EQ bypassed) to get rid of the noise, it sounds mediocre. Too much bass and slightly muffled. I can boost the highs a bit with the EQ to counter the muffled sound, but then there's noticeable sibilance distortion. It sounds quite a bit clearer just going directly through the Samson EQ into my amp with an EQ curve to compensate for the lack of phono preamp, albeit with more noticeable crackle & pop. I have cleaned the stylus for what it's worth, though its condition is unknown.

Edit: On a whim I tried swapping the left and right channels and... that fixed it. It sounds great now, no EQ necessary. I also had to jiggle the connectors a bit to get a hum to go away, so I think the stock RCA connectors are just crapping out.

UPDATE: Replacing the RCA connectors completely fixed the issue.

— 0