Slow Read Speeds from Array Seagate Disks During Duplicati Backup
Top line: When transferring large sequential reads from my array, the 20TB Seagate Ironwolf Pro drives (7200 RPM) have sustained average read speeds of \~30MB/s. However, the 20TB WD white label Red Pro drives in the same array transfer data with sustained write speeds of \~170MB/s. But if I stream Plex from any disk in the array, the Seagate drives boost their read speeds to \~150MB/s.
Details:
I have an eight-disk array: seven data disks and one parity drive. Four of the data disks are retail Seagate Ironwolf Pro 20TB drives. Three of the data disks are shucked WD white label Red 20TB drives. The parity drive is a retail WD Red Pro 20TB.
I recently set up another unraid server to act as a backup for my \~84TB of data. I started transferring data via Duplicati last week, and noticed that the Seagate drives transfer data at a much lower average and sustained rate compared to the WD drives.
The connection is as follows: 5gig NIC on the primary server to a 10gig switch, to a 10gig NIC on the backup server. iperft3 shows data transferring at \~5gig/s. For testing the read speeds and so as to not be bottlenecked by the array on the backup server, I've been writing to cache on the backup server.
The results are that when backing up data from the seagate drives, the read speeds average about 30MB/s with very rare peaks around 200MB/s for a few seconds. However when the array is backing up data from the WD drives, average read speeds are around 150MB/s with peaks around 190MB/s.
But here is the weird thing I found: If I stream plex data from another drive in the array during the backup, the Seagate drives will increase read speeds to an average around 150MBs with peaks up to 210MB/s. I've been testing this to confirm off and on for the past 24 hours, and it's pretty consistent.
When I stop streaming plex movies, the average speeds go down to 30MB/s again. When I start up the streaming, speeds increase almost immediately. See images below for examples. I've resorted to streaming a high-bitrate UHD movie on repeat in a guest bedroom just to get peak transfer speeds on this backup.
Any ideas what is happening here?
Image note - there is a heatwave here in CA with multiple 100 degree (F) days. So ambient temps are high below:

