Olympus TG 5 stripped plastic tripod thread fix
Was racking my brain for a while after my plastic tripod threads were stripped. Why Olympus? The metal replacement was abit too wide and deeper than the current tripod socket. Contemplated using a Dremel to make a bigger hole but read that their might be important components underneath.
Photos [https://ibb.co/Cz6fZ1T](https://ibb.co/Cz6fZ1T) [https://ibb.co/WKhLzzG](https://ibb.co/WKhLzzG) [https://ibb.co/M7ggbQd](https://ibb.co/M7ggbQd)
Solution: use the tiny plates found on top of mini tripods/selfie sticks, the plate where your camera sits on. Found a metal one and used the Dremel to make grooves in it. Did the same thing on the bottom of the camera so that the glue can hold onto. Used a 5 minute epoxy. Place tape over it to keep it in place while it cured.
One big mistake i made was not filling the thread hole in the plate so it filled with epoxy. Earlier I had covered it when i was creating groves in it. Probably recommend putting Blu tak in the thread hole or something that's easy to remove after the epoxy sets. I still managed to dremel some of the epoxy and scrapped back the epoxy with a small flat head screwdriver and using a tripod plate to screw in and out to create the threads again.
I just finished it, so I can't comment on its longevity but seems pretty solidly attached and happy to have a tripod socket again,