More Sansui 5050 questions
Hello all! Thanks in advance for your help. So I’ve discovered in completing a rebuild kit for 5050, that I have one of the builds that seems to look nothing like any of the references in the manual or the instructions to the rebuild. So I’m sourcing to you for two questions: First: adjusting the bias. The manual says to attach leads to R5+R7 and then R6+R8. In the manual those are all the same size resistors (though in mine they do all do appear to have the same rating, why the different form factors? If each pair is for a separate channel why would each channel look so different/be in a different place on the board?)
The instructions on the rebuild kit suggests I clip on to each end of the white sandcast resistor that connects to the output transistor. When I tried this the first time I blew up at least one transistor and burned up a resistor on the driver board.
And the YouTube videos I’ve watched on different Sansui receivers connect directly to the transistor.
So what do you think? What is the best place to clip on to set bias after seeing my unit?
Second question: the kit came with parts to replace on the input selector switch. My input selector switch has no cap, transistor or resistor on it. A photo I found for a listing for this part does in fact have these parts. Is is recommended that I “upgrade” my selector switch with these or leave it alone. If I should add them does anyone have instructions on how to do so?
Thanks all!