Installing new mainspring in a barrel is it supposed to be this hard?
I thought getting a new mainspring spring and just push it in to a barrel would be easy but after 60 dollar down the drain and 2 main springs gone as well :( here is the video of me trying to do this i tried using the back side of tweezers as well as just trying to push it in using my thumbs and both main springs didn’t want to go in. This video is when i used the back side of a tweezer. The barrel is 11 mm the wound spring was 9.9 - 10mm so should have fit easy. In this video i made sure it was in the center of the barrel and had its protruding body in the barrel boundary as well. It is not clear in the video but at the very end the middle part of the spring went in while the sides were high so it made kinda like a bowl shape. The other one did the same thing I made sure to push in the bridle part first but i think it did not want to go in. Please teach me if there is another easier way found a 3d print but that requires a diffrent setup for each size barrel.
https://photos.app.goo.gl/2C4QHh3cejQd497G8