Finishing up my build
Bro in law got me a waterblock for my Sapphire RX 7900 xtx Pulse for Christmas/birthday (I told him he could combine if he wants since it was a big purchase). (Funnel replaced with cap after I took the picture because I was still bleeding air from it)
I got some additional radiators to mount for the added heat dissipation. (1x 240mm rad, 1x 120mm rad, 1x 140x45mm rad) + D5 pump hidden in the bottom of the case
According to NZXT, it is impossible to mount a radiator on the top fan location, and they are right, the case isn't built to accommodate a radiator *inside* the case.
Drilled two holes for the fittings and slapped it in the top of the case with push/pull fans. Also got a chance to visit Microcenter while visiting folks for Christmas and got some Montech E28 ARGB 120mm fans since they had better static pressure than the Corsair fans I was using.
The Arduino in there is reading the water temp from the probe at the bottom of the reservoir, sending that to a python script running as a windows service which then writes that temp to a file on disk. FanControl then reads that file and allows my to set my temp curves on the water temp instead of core temps.
At full power (~480w (Ryzen 7 5700G and Rx 7900xtx over locked a bit)) my water temps stabilize at between 38C and 40C.
Not too shabby :)