RedditPP Mascot

RedditPP

r/watercooling • … • u/Xobl

EKWB Quantum Vector EVGA 3080 XC3 Ultra Block

Had a few questions about mounting the block to this card:

1. I noticed the thermal pads supplied by EKWB to be used with their block are all 1mm thick, yet the stock EVGA thermal pads used for the stock cooler vary in thickness. With the exception of the chokes, can I still expect all the other components to make proper contact with the block? 2. After gently mounting the block, can I remove it again to check and see if the thermal paste on the die has spread evenly? Or will removing the block again harm the thermal pads by stretching/etc? 3. When cutting the thermal pads for the memory modules and mosfets, should I cut individual squares or is it okay to cut a long continuous strip and lay that down over each row?

​

I know these are all pretty silly sounding questions, just wanted to be super careful and do this as correctly as possible.

— 0