RedditPP Mascot

RedditPP

r/wheelbuild • … • u/utack

First wheel - question about trueness at the seam

Hi all,

I just built my first wheel from a Ryde Andra 10 and have a question about trueness at the seam. I managed to get the lateral trueness, radial trueness dishing and tensions within very good range at my second attempt, but there is one exception: At the seam there is one very short local "arc" (about 4-5cm) that is going about 2mm to one side and is a bit higher. There is one spoke in this area and it would take absurd tensions to attempt to fix that spot. Do I just accept that this is a tricky spot and a bit out of spec or did I do something wrong?

Thanks for your input

— 0