RedditPP Mascot

RedditPP

r/woodstoving • … • u/PapaShane

Getting my first stove this week and doing DIY install; thermometer needed? Installation difficulty? Buck Stoves questions.

So yep, finally bit the bullet and will be picking up a Buck stove insert this week. I will be tackling the install myself and have a few quick questions that I haven't been able to answer after browsing through this sub for a few days. This stuff all seems simple but the consequences can be severe so I figured I'd just ask! Sorry for the long post...

First; regarding the Buck 74 stove, how important is a blower and a surround kit for use as an insert? This will be going into a masonry fireplace, will we need to order the surround trim for the stove to heat properly? Or a bottom plate to close the bottom of the flue? I think I understand that these stoves are jacketed and that hot air naturally is ejected from the interstice so a blower isn't necessary but would help... is that accurate? I have been able to find a lot of this info but not as it pertains to Buck stoves in particular, which from my understanding are designed a bit different than a "normal" insert or cast iron stove.

Second, the installation. I went with a "Ventis" pre-insulated double wall flex pipe kit, which includes the top plate, rain cap, 35' of pipe, and an appliance connector. The manual shows it's made by Olympia and is simply lowered down the flue, seems very straightforward. Which makes me wonder why I was quoted nearly $5k for a chimney company to do this work! Am I missing something, or is it really that simple? Oh, and should the bottom section of the stove pipe (area around the connection to the stove) be insulated with extra rock wool? To fill space around the flue? And how do you deal with tight access behind/on top of the stove when you hook up the vent pipe? Can you go in through the stove to grab the inside of the pipe?

And third, thermometer usage. Is a pipe thermometer necessary, along with a thermometer on the stove face? Is there a probe thermometer that I'd be able to install through the double wall pipe inside the flue and then have a remote gauge so I can actually read the temp? I'm not sure how to go about monitoring the temps inside the pipe when the pipe is inaccessible inside a chimney.

Oh, bonus question! If I have access to a lot of dead standing ash... is that stuff pretty much ready to burn after splitting? My wood stack is not very big yet and is mostly maple, but there are dead ash trees everywhere. Would love to be able to get some good use out of the stove this winter/spring but would rather not burn unseasoned maple, so can ash get me going pretty quick?

Alright that should do it for today! Thanks for any tips and tricks and advice, this sub seems amazingly supportive and knowledgeable with some fantastic mods, it's been a lot of fun browsing through the pages and I've definitely learned a lot (at least, enough to know what questions to ask!).

— 0