RedditPP Mascot

RedditPP

r/woodstoving • … • u/swordmastersaur

Joints leaking after cleaning

Have an intrepid Flex burn from Vermont castings

Brand new

Had my stove cleaned professionally last year

Learned how to do it from the cleaner, ordered my stuff, and used it for two winters, very few problems that weren't my fault.

Cleaned it myself this year, took out a few sections, and used the same brush to clean the chimney

Had to wait a bit for some new ceramic fiber paper to replace what I chuckled up below, but got it back together. Replaced the fiber glass gasket around the flue collar with Rutland stove sealer

Got the test fire going, and the joints are leaking, only the ones I touched

Everything I saw online says it's because of air pressure,

First time I fired up to test it, the wind was blowing hard, and it was April, so warmer then the winter, no biggie

Currently firing again, and still got smoke leaking out of areas

Pretty sure I put it together exact same way it was, and over winter saw some missing bolts without smoke coming out previously.

Yet now got a noticeable amount of smoke coming out

Not smoking me out, but certainly different from previously

Also seems to start slowing down with ash door closed, even with the damper and air controller wide open, while previously it burned merrily innsuch a state

Would really like to not burn the house down, and have it ready for next winter

Would greatly appreciate any insight going on with my issues

— 0