RedditPP Mascot

RedditPP

r/woodworking • … • u/Vikutta

How to flatten/unwarp basswood?

Hello all! I've been working on a wood project for a friend and this frame I made came out slightly warped, so now when it is lying flat, two opposite corners are slightly lifted and aren't flush. The opposite corners raise about 2mm from the surface it is resting on, kinda like a mini teeter-totter.

​

**How I made this piece:**

I cut out a square from a plank bought from Hobby Lobby. I then cut the square diagonally so I could cut out the inner wood to create a frame. I then used wood glue to glue the two frames together to get what you see in the photo. The cutting was done with a bandsaw. (Perhaps my cuts weren't perfectly straight?)

The wood is basswood, it is a 1/4" thick, and the frame in the pictures is about 4.72" x 4.72" (120mm x 120mm)

​

**Probable solution? :**

I did buy two quarter-inch aluminum plates so I could use a clamp to help flatten it out (after putting warm water on the wood?) but I wasn't really sure if this was the best method especially if I'm soaking/wetting the wood. I don't know how this wood material will react to that, how long it takes to absorb to become malleable, and I don't know how to apply the water (A coworker suggested heated steam). I may restain it (It doesn't have a protective coat on it yet) after I flatten it out.

I would like to retain its thickness as much as possible if other solutions are proposed.

​

I'm very new to woodworking, so I'm hoping to learn better ways of doing this as well! Any help is greatly appreciated!

![img](6xs38i4edgcc1)

![img](l38kxk4edgcc1)

![img](tsgcsl4edgcc1)

![img](rpnpoq4edgcc1)

![img](0ac5er4edgcc1)

— 0