RedditPP Mascot

RedditPP

r/woodworking • … • u/username-in-the-box

Jointer setup question, coplaner

I recently posted about setting up my grizzly jointer tables to be coplaner.

I ended up using pieces of soda cans to shim all of the sides of my outfeed table.

However, I can’t get it perfect. Currently I’m at 0 on the front between the 2 tables but I’m at .0025 low in the rear of the tables on the indeed side.

Should I keep hunting for 0 or is .0025 on one part of the tables good enough?

The reason I went on this mission is I was noticing that the jointer wasn’t getting the pieces flat and was introducing some weird movement.

— 0