Sword rack update
Well, it's done. Thanks for everybody's advice on the other thread.
Band saw would have been the best tool for the job, but it don't have one, and wasn't sure how often I'd use one if I bought it, so... Started with a forstner bit, removed the hulk of the waste with a hand saw, then followed the profile lines with a router table and belt sander.
The router step was tricky because too deep a cut makes the bit grab onto the wood and pull it, this going even deeper. At some point I messed up and part of the work piece broke off (2nd pic).
Overall this is very far from perfect, but it was a learning experience, and for $13 worth of cherry, well worth it compared with buying one!