How to cut repeatable lenghts of board with a tracksaw
I have a Makita tracksaw that I absolutely love. However, I have a slight problem with repeatable cuts when making short pieces out of long boards. (lets say 22x100mm board, 3000mm long)
When you are cutting with tracksaw, the track should be on the KEEP side. Lets say that my project needs several 200mm pieces and I have one perfect sample ready. I am in the process of cutting them from a longer board.
When I cut long boards, my process is to lay they board on some sacrificial material and support the track with offcuts taken from a similar board. I will then use a carpenter square to to square up the track.
How can I use the sample to get the exactly correct length? If I place it on the CUT side, ie. next to the track's rubber, I have to eyeball the kerf width or I will get slightly too short pieces. The results are pretty good, but they could be better.
Obviously I have other types of saws that could be used, but the SP600ZJ is so quiet and nice that I like to use it for most of the cuts. What I am looking is a really simple technique or a small jig.