RedditPP Mascot

RedditPP

r/woodworking • … • u/Cautious_Grab_3735

Correcting for a slightly warped bench top.

I made a mudroom bench top (6’ x 2’ and about 1.25” thick) from three cherry boards, which I jointed and planed, but didn’t get perfectly flat. After glue-up and clamping there’s a slight diagonal twist to the finished bench top — when I push the left side down, the front right corner is raised slightly less than 1/4”. I’m trying to solve for that, and my thought is to put a screw in each of the corners from underneath the bench when I get it in place to “pull” it down flat.

Is this appropriate, and would I need a threaded insert, or can I just screw directly into the wood? I figured I’d use a steel corner “L” brace since they’ll be hidden.

— 0