RedditPP Mascot

RedditPP

r/woodworking • … • u/esaule

Routing complex pattern accurately

I am trying to route somewhat complex patterns in wood and I'm kind of failing at it.

The technique I followed was to glue a stencil and clamp a fence on each side around each line one line at a time. Then plunge a router by lowering it secured by the two fences and route by hand.

The result is not great. I am running into a few issues.

1/ The lines still aren't quite straight.

2/ In the smaller pattern some of the wood broke, following the wood grain. (I glued it back.) Do you think that routing at a 45 degree angle from the wood grain would prevent that?

I am still planning on cleaning it up and see what I get; but I don't think it will ever look good.

Am I using the wrong technique here? Should I just get good? Or is that why we invented CNC machines?

Any advice?

— 0