RedditPP Mascot

RedditPP

r/woodworking • … • u/XCOM_Fanatic

Basic bookshelf technique question (dealing with slight warp on back)

Appreciate the help you all gave last time.

Say your shelf fits either end of a bookcase perfectly, but the back is a touch warped out in the center. Such that you can't get both ends flush at the same time. The back is fairly stiff (1/2 ply).

I have a few ideas:

A) Glue and brad nail one end flush (from the side and back both). Then hope to heck with a rubber mallet that you can get the other end to flush long enough to get a nail in.

B) Buy clamps deep enough for the bookcase front to back, see if you can't clamp both ends in first before any glue is used.

C) Cheat with a construction screw from the back in each corner. Could use this to rescue A.

D) Some kind of crazy thing to try to unwarp the back.

Thoughts? Is any of these right, or is there a better thing I'm not thinking of?

— 0