RedditPP Mascot

RedditPP

r/woodworking • … • u/EnthusiasticAmature

Router Oddity - Thoughts Appreciated?

For jointing strips in cutting boards I use my router with the infeed fence set 0.0015" behind the bit and outfeed fence. If the wood is stable I get glue lines that almost disappear without clamping.

Decided to make this next board a little thicker so I switched to an Ultra-Shear US5200FTU (flush trim 1/2" bit 2 flute upcut, 2" cut length) and got the results in the pictures. This piece has a definite convex surface after 3 passes. (It was visable after the first pass but I didn't believe what I was seeing.)

Anyone seen this before? That's an expensive premium bit so I'm having a hard time believing the bit is the issue. I'm also struggling to come up with something in my setup that could explain this.

Previously I used a 1 1/2" straight cut bit in the same set-up. No issues there.

— 0