Measure once, cut twice (or don't measure at all)
I finished making several frames for a client (details not important). Overall it's a simple build of just a big rectangle and a cross beam in the middle for support. During the dry fit before glueing, I noticed the cross bars were too short by only a few mm. Apparently 3 of us didn't notice that the beams we ordered were slightly too small. We ordered 30mm x 30mm and recieved "about 29” (even that wasn't consistent, as it went down to almost 28 in some sections).
My solution was fairly, glue on a single sheet of verneer on the cross beams to make up the difference (the OD was important). It wasn't difficult at all, just annoying that it took extra time.