RedditPP Mascot

RedditPP

r/woodworking • … • u/chucklefits

Drawer slide options

Howdy y'all, I built this vanity for my bathroom, it's a small bathroom so the depth of the carcass is only 14". I am planning on doing inset drawers to show off the curly maple grain of the faceframe, I'd like to do undermount push up open slides so there's no pull hardware but at that shallow depth I'm not seeing anything, anyone have a secret recommendation that would make this possible? Worst case scenario I add a cutout of some kind to the drawer faces and just run soft close slides or use side mounted push to open slides but it's not the look I'd prefer. TIA

— 0