RedditPP Mascot

RedditPP

r/woodworking • … • u/NeopetsIsTheShitt

Birch and walnut sword made from a piece of hardwood flooring and some other scrap

Trimmed the birch hardwood down with my tablesaw on all 4 sides to remove the grooves on the sides and bottom and the finish that was on the top. This would probably be easier and safer if i had a decend bandsaw. Cut the angle on the top with a jigsaw. For the blades bevel I just set my tablesaw to 22 degrees and then ran the pieces through leaving about ¼ inch on the front of the blade. To get the blade looking a little sharper I just sanded it down.

The handle is just a two pieces with a dado carved down the middle. In the past I used a router bit to round the sides but found I still needed to do a lot of sanding to get the grip to feel comfortable. So this time I ended up using an angle grinder with a 30 grit wood sanding disk to get the oval shape and then cleaned it up with an orbital sander. They get sandwiched around the tang. A small piece gets glued onto the bottom as the pommel and then I round it over and make it flush with an orbital sander.

I normally use lacquer on my swords but it was giving the Birch a slight bit of amber hue that I didn't care for so I used a water based polyurethane instead.

This one was a lot easier to make than some of my other katanas because the blade wasn't curved so I could just run it through my table saw and I didn't need as much sanding to get it even and consistent.

— 0