Help with Maple Butcher Block Staining





Hi everyone! I attempted to stain this butcher block with Minwax Waterbased Dark Walnut Stain, but some parts came out blotchy and uneven (see first picture).
I pre-stained it with Minwax Pre-Stain Waterbased Conditioner, and used a LVLP paint spray gun to apply the waterbased stain - and I most likely applied too much without wiping off the excess. No polyurethane has been applied.
To help with the blotchiness - I sanded from 80 - 120 - 180 - 220
After sanding, I was left with visible open spots on the tops and sides (see remaining pics)
What would your advise to "fix" this? I have not applied any polyurethane - just water based pre-stain and water based walnut stain.
Thank you!