RedditPP Mascot

RedditPP

r/woodworking • … • u/RupusMiltai

How to achieve inner roundover?

Hi, I'd like to build a console table with similar corner features (inner and outer roundovers). I'm looking for advice on the process. Here's what I'm thinking so far:

\- The panels would be about 20mm (3/4 in thick)

\- I'd like the roundover to be continuous along the depth of the piece (not just a separate trim detail)

\- Therefore the corners would be separate pieces, inner radius about 25mm (1 in), outer radius 45mm (1 and 3/4). The radii do not need to be precise, but I would say at least 25mm inner radius for desired effect.

I can think of 2 ways to prepare the corner pieces, both would produce a cove for 2 corners, and then the piece would be ripper in half

Option 1: Cove cut on a table saw. Start with a piece twice the width of a corner (basically 2 corners). Cut a cove by slowly raising the blade height. Once desire cove depth is achieved, rip the piece in half to produce 2 corner pieces. I've experimented with cove cutting before, so I would be comfortable performing this. But I'm having difficulties estimating the temporary fence angle, as well as figuring out what sort of diameter cove would be produced (I guess using smaller blade would be better?)

Option 2. Again start with 1 wider piece, but cut the cove with a router bit on a router table, slowly raising the cut height. I am a bit concerned of using a bit this large, and I currently only have much smaller router bits.

Is there anything that I'm missing? Any easier way to achieve this?

For the outer roundover I'm thinking of this gluing on the parts, then marking the roundover with a pencil, and using electric planer / belt sander / orbit sander until the even thickness is reached.

— 0