🚨In the Interest of Public Safety🚨
Looking at you, u/Low-Bluebird1494!
I 3D-modeled some dies for removing and installing the bezel on a 41mm Datejust.
The setup consists of three main parts:
* **Base** * **Bezel Press** * **Crystal Press Insert**


Here’s the watch head in the press, with the crystal press insert positioned in the bezel press die:

Lined up for removal:

Short video of the removal process:

The result: bezel and case separated into two pieces:

Installing the bezel is straightforward, but I’ve included a video for reference:

I designed this with as few parts as possible, using only a couple that required threaded inserts. Technically, you could print them without the inserts since the alignment isn’t critical, and minimal force is required.
I’ll include a link in the first post where you can download the files and print them yourself. Just a heads-up—I take no responsibility if you pinch your finger!